We are specialized in the manufacture of the brake assembly line. Here is a brief introduction to the maintenance method of the assembly line.
1. The motor, chain, and reducer of the automated assembly line can be said to be the core components of the entire automated assembly line equipment; compared with the components of the entire automated assembly line equipment, it is necessary to understand some basic automated assembly line maintenance methods.
1. Maintenance method of the head reducer of the automatic assembly line: After about three months of first use, drain the oil in the reducer, clean it with diesel or gasoline, and immediately add new lubricating oil in the middle of the observation window. The lubricating oil can be changed every year. Excessive lubricating oil may cause the reducer to heat up, and excessive motor load may cause the motor protection switch to trip. Too little lubricating oil may cause the reducer to heat up, increase the noise, and the reducer may be hung up and scrapped.
2. Maintenance method of the chain: After long-term operation, the original lubricating oil may be volatilized by heat, resulting in unbalanced operation, increased noise, and crawling. At this time, open the sealing plate at the tail and add butter or thick lubricating oil to the chain.
3. The most important point is that the motor must not enter the water, do not add diesel oil and liquid organic compounds to the motor, because this may cause insulation damage and motor failure. For the rest, check motor care and maintenance in your electrician’s manual.
Our company has many other products, such as a starter assembly line, welcome to visit our website!